585,758 active members*
4,445 visitors online*
Register for free
Login

Thread: Miyano Live-Tool

Results 1 to 3 of 3
  1. 10-20-2005, 05:29 PM #1
    JerryH
    JerryH is offline Registered
    Join Date
    Sep 2005
    Posts
    39

    Exclamation Miyano Live-Tool

    I'm having trouble getting X-axis to feed when using revolving tool. Machine will rapid to position fine, but when I program in an x-axis feed move (G1 X-.06 F1.0), machine will stop and read no further. No errors, just the run light and no movement. Fanuc OT control. Any suggestions?

    Current Program:

    T0606 (Live Tool)
    S2000 M43 (Start revolving tool spindle)
    G0 H-4.375 (Position Sub-Spindle)
    G0 Z0
    G0 X.100
    G1 X-.06 F1.0 (Feed X-axis)
    G0 X.100
    G28 U0
    G28 WO
    G28 H0
    M30
    Reply With Quote Reply With Quote
  2. 10-21-2005, 12:44 PM #2
    cogsman1
    cogsman1 is offline Registered
    Join Date
    Jan 2005
    Posts
    304
    You need to go into IPM feed mode (Inch per minute) Should be G98 but check your manual.

    G98G1X0F10.
    Reply With Quote Reply With Quote
  3. 10-26-2005, 01:50 PM #3
    JerryH
    JerryH is offline Registered
    Join Date
    Sep 2005
    Posts
    39

    That did it

    Thanks Cogsman!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules