Hello All,
I have a Gerber 408. When we run a job it starts fine but after about a minute the spindle stops running but the X & Y keeps going. Anyone have this issue before?
Hello All,
I have a Gerber 408. When we run a job it starts fine but after about a minute the spindle stops running but the X & Y keeps going. Anyone have this issue before?
Not happened to me.
Sometimes when the spindle stalls it will stop but then I will get an X or Y axis failure and need to reboot.
What size spindle?
What material? Speed? Feed?
Is this consistent?
Any error codes on the VFD?
Hello Comeco,
we also run a Sabre 408 and have just experienced a similar problem as described in your post of 12-05-2011 : right in the middle of a job the spindle stops running but x any keep going.
We wonder if you have solved this problem and would be grateful if you could let us know.
Best regards.
Jan Dewever
Maessen plastics