The active WPC remains in effect within the EIA sub, but any current offset units do not. Is there a parameter perhaps that will change this?
The active WPC remains in effect within the EIA sub, but any current offset units do not. Is there a parameter perhaps that will change this?
.
Parameter F
70 needs to be a 1. This will allow the offest to carry to an eia program.
hmmm, F70 talks about multiple machining and # of repetitions... I would have never guessed that one. Thanks, I'll check it out in the morning.
thank you bildoo, works perfect
too bad the manual gave no inkling that that parameter would have the desired effect