585,974 active members*
4,338 visitors online*
Register for free
Login

Thread: drivers

Results 1 to 2 of 2
  1. 12-14-2011, 02:56 AM #1
    Rue0034
    Rue0034 is offline Registered
    Join Date
    Dec 2011
    Posts
    3

    drivers

    i have a cnc table with ghecko 6210 stepper drives. Can you mix drives if I want to go with a different brand?
    Reply With Quote Reply With Quote
  2. 12-15-2011, 03:40 AM #2
    James Newton
    James Newton is offline Registered
    Join Date
    May 2005
    Posts
    1397
    Absolutely.
    James hosts the single best wiki page about steppers for CNC hobbyists on the net:
    http://www.piclist.com/techref/io/steppers.htm Disagree? Tell him what's missing! ,o)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. IMS drivers vs. Gecko drivers
    By cnczoner in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 04-05-2010, 04:50 AM
  2. Can i use these drivers
    By erase42 in forum Servo Motors / Drives
    Replies: 2
    Last Post: 01-25-2007, 04:35 AM
  3. old drivers
    By erase42 in forum Xylotex
    Replies: 1
    Last Post: 10-23-2006, 11:08 AM
  4. my drivers
    By xtihc in forum Stepper Motors / Drives
    Replies: 22
    Last Post: 02-20-2006, 05:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules