[murfeedean]

I have a multicam 3000 & I am getting a "motor error 23 xa, y, z" when booting the machine up. The last thing it tries to do before it crashes is " enabling motor drives". Will not allow you to initiate home settings. It is kicking out the contactor to the AC drive when trying to set the Z axis. Any Ideas?

Regards,

michael

[MCPservice]

Sounds like your Bridge Rectifier is bad....

[murfeedean]

Changed it out & it kicked the switch off. Still no power to servo #1. unhook one side of the capacitor & it don't shut down.... Ever heard of a capacitor go bad on one of these things?

Thanks for responding.

Michael

[MCPservice]

Just curious do you verify that the bridge rectifier was installed in the right orientation, if install reversed the same error will happen.

[murfeedean]

I have a multicam 3000 & I am getting a "web fault error" when booting the machine up. It is kicking out the contactor & the circuit breaker to the AC drive as soon as it tries to " enable motor drives". Will not allow you to initiate home settings. If you try to set it by the Hand controller pad it gives error "24 volts over current" We changed out the bridge rectifier, Contactor, capacitor & the mother board. Any help would be great.

Regards,

michael

[murfeedean]

Hi, just wondering if anyone had any ideas? I am getting a motor fault (0x 4)
Drive 3 (z) Blink count 5

It gives me that error when trying to home machine.

Thanks for your time.

Mike

[MCPservice]

Blink count 5 is normally a mechanical issue,
1. Z-screw is dirty
2. Z servo is dirty, sometimes your material that you are cutting get down into the upper bearing of the servo.
3. Bearing cars are shot and need replacement.
4. Ball screw itself has blown bearings and needs replacement.
5. The pulley on the top of the z-screw has shifted and is rubbing against the top to the support plate. EASIEST TO CHECK
WORSE CASE:SERVO AMP IS SHOT, and needs replacement.

[murfeedean]

Thanks for the information :cheers: The bearings on the ball screw are shot!

Thanks again,

Mike

[murfeedean]

Multicam 3000 motor fault Multicam motor fault (0x 4

--------------------------------------------------------------------------------

Hi, just wondering if anyone had any ideas? I am getting a motor fault (0x 4)
Drive 3 (z) Blink count 11:stickpoke:stickpoke

It gives me that error when trying to home machine.

Thanks for your time.

Mike

[Gabestter]

did you ever get an answer, how did you resolved it? I'm having the same problem.
Thanks