Hi Guys,
(Larry I left a message on your machine)
I am pretty much 95% done with my Matsuura retrofit, I plugged 12VDC power into the Viper 200 (I believe its a 200F), got a solid green light and a red blinking 4 times then off, then 4 times repeatedly, which based on the manual means there's no main power which is correct, I am trying to make sure the encoders are working properly like the instructions state.
When I plug the RS232 programming cable onto the card, it basically kills the power (I can see a small spark in the RS232 white connector when I plug it in)
Any thoughts? I was using an external bench top 12V supply for now, because the power supply I will be using to power the control power has not yet arrived.
I also tried removing the ground pin on the RS232 connector, and then the card stayed on, but I could not get any communications with hyper terminal no matter what I tried.
Any help is greatly appreciated,
Thanks,
Andy