[Snipes44]

Thought there maybe some others that might find this useful. I have recently acquired a KMB-1 mill and Hurco was kind enough to send these to me. Was really hoping for a wiring diagram but they don't seem to have one any more.

KMB1m Operation Manual May 1983

KMBX1 Operation Manual Oct 1983

[Snipes44]

Here are a few more documents related to the Hurco KMB1 (KMBX1) mills.

- Electrocraft servo data sheet for Hurco part number 401-4003-003, Electrocraft part number 0700-02-049, which I think also works for Electrocraft part number 0700-02-089 since the motors have the same Hurco part number on them.

- General servo wiring diagram.

- General transformer wiring and power distribution.

Hopefully these will help someone down the road.

[Snipes44]

Just got this servo datsheet from Electrocraft.

Part number 0703-02-089
Cust Part number 401-4003-003

[Snipes44]

Just got this encoder data sheet from BEI. Encoder number is MX21-566. Hurco part number I think is 416-0248-010. Hopefully this helps someone down the road. This is what one of my encoders was on my mill. They other 2 are of an older vintage.

[tjs]

I may have wiring diagrams for a kmb1. I am in the process of scanning the prints I have. If you are interested, i would share.

tjs

[Snipes44]

That would be awesome. You could just post them here so others can find the also.

[tjs]

Here are the 1st batch. I have 30+ prints in all, but I will start with these. unfortunately, my scanner will only do 1/2 page at a time so each print is labeled left & right. hopefully you will find these helpful. if there is a specific page or item you are looking for, let me know & I can get that up asap.
Also, if there is a better way to share these, I am open to that as well.

tjs

[Snipes44]

How are the scans going? Not sure if you have got the it yet, but I could use the pages that are related to the DC servo power supply.

Thanks
-Wes

[Snipes44]

Just found this for the limit switches on on the mill. Micro Switch 101XK5-1 7944.

[tjs]

Here ae another batch of hurco electrical drawings...

[Snipes44]

Here is the manual for auto-lube pump

Thanks to Bob_La_Londe for posting this.

[MarkGaiser]

Hi,
I would be interested in these KMB1 Schematics. I tried to copy the files posted on the blog, but all I get is a very low-resolution scan version.