[Rukam22]

Hi,
I want to to change my sub program for bar feeder and I need some help.
Right now after feeding the bar is finished, the spindle starts, but my push road is still inside in spindle.
I want the push road to be outside the spindle back in bar feeder and after spindle to start.Can anyone help me?

%
O9001(ELEC. BARFEEDER SUB-PROGRAM)
IF[#1000EQ0]GOTO10
G0W50.M19
M72
#100=0
WHILE[#1001EQ0]DO1
G04X0.1
#100=#100+1
IF[#100GE#615]GOTO2000
END1
G0W-47.5
M65
M71
M98P8020
M99
N10M72
M65
M71
M99
N2000#3000=1(BF NO EJECT)
%

%
O8020(ELEC. BARFEEDER SUB-2 PROGRAM)
G0W50.
T0606
G0X-50.G96S180M3
Z0.
X-19.M8
G1X5.F0.2
X0.5F0.08
G0X-19.
M99
%

M63 BAR FEED ALARM CHECK
M64 CANCEL END OF BAR
M65 BAR SUPPLY FINISH
M66 BAR FEED LOAD IN
M71 CHUCK CLAMP
M72 CHUCK UNCLAMP

[Prayer]

Is it going out of the Spindel, but don't get fully retracted before the Spindel starts?

[Prayer]

Hi,
I want to to change my sub program for bar feeder and I need some help.
Right now after feeding the bar is finished, the spindle starts, but my push road is still inside in spindle.
I want the push road to be outside the spindle back in bar feeder and after spindle to start.Can anyone help me?

%
O9001(ELEC. BARFEEDER SUB-PROGRAM)
IF[#1000EQ0]GOTO10
G0W50.M19
M72
#100=0
WHILE[#1001EQ0]DO1
G04X0.1
#100=#100+1
IF[#100GE#615]GOTO2000
END1
G0W-47.5
M65
M71
M98P8020
M99
N10M72
M65
M71
M99
N2000#3000=1(BF NO EJECT)
%

%
O8020(ELEC. BARFEEDER SUB-2 PROGRAM)
G0W50.
T0606
G0X-50.G96S180M3
Z0.
X-19.M8
G1X5.F0.2
X0.5F0.08
G0X-19.
M99
%

M63 BAR FEED ALARM CHECK
M64 CANCEL END OF BAR
M65 BAR SUPPLY FINISH
M66 BAR FEED LOAD IN
M71 CHUCK CLAMP
M72 CHUCK UNCLAMP

Im not familyar with your barfeeder, but i have this https://www.scribd.com/document/4034...2017-11-20-pdf

On my model I control the retract-point on the feeders control panel, an not in the G-code.
But if its starting rpm, before fully retracted, i would run a feed-cycles in singleblock to localize where it happens, and add a Dwell-time.

[Rukam22]

yes