Has anyone ran an Esab 650 on a torchmate table, I was reccomended hypertherm 45, but the price difference is almost 1200$, we are cutting anything from 1/8 aluminum to 3/16 inch mild steel on a regular basis , we may want to go thicker at some point but for now this is our main needs and wondering if anyone has ran this combo and what the results were, my main concerns is with the local cnc guy we are using we have a lot of clean up after the cuts, meaning some of the cuts are close to 90 degree, some are completely slanted, holes are not correct size, or screwed up with slants and just tears up drill bits, and he is using a hypertherm 45, now i dont know how much of the issue is him , or the machine... any advice?