My 4400 drops into alarm mode as soon as I power up the controller. Screen reads :
<NC ALARM> ALARM DIAGN 1
S04 AMP CONNECT OFF
Y04 AMP UNEQUIPPPED
<STOP CODE>
<ALARM MESSAGE>
<OPERATOR MESSAGE>
I thought I had isolated it to the valve which controls the clamp/unclamp cylinder. Replaced the valve (actually had to scab a new valve in, as the OEM Taiyo valves are no longer available in the US) and the problem went away, only to recur on the next start up. I can't really make heads of tails or the O&M manual with regard to alarms and troubleshooting.
I'd really appreciate suggestions, as I'm desperate to get this machine back up and running.