Does anyone have a post for the Anilam 1100M control?
It's a old one, but we have one sitting in the corner of our shop that I could utilize if I had a post.
Thanks everyone and have a great weekend!!!!!!
Does anyone have a post for the Anilam 1100M control?
It's a old one, but we have one sitting in the corner of our shop that I could utilize if I had a post.
Thanks everyone and have a great weekend!!!!!!
If you can't locate an ANilam 1100 post you can use a Fanuc 0M post then run the G-code program through the G-code to Conversational converter. It's under the PROGRAM page under the Utilities key.
Regards - Tim