585,605 active members*
3,180 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > EnRoute > EnRoute 3.3 and Multicam 6610

Thread: EnRoute 3.3 and Multicam 6610

Results 1 to 1 of 1
  1. 01-21-2012, 12:02 AM #1
    jhansLV
    jhansLV is offline Registered
    Join Date
    Jan 2012
    Posts
    0

    Question EnRoute 3.3 and Multicam 6610

    Hi all,

    We're having a bit of an issue with getting our Multicam fired back up. Had some hardware trouble with the PC that required reinstalling Windows. After putting EnRoute 3.3 back on, we can't send output to the Multicam (which is connected on COM1).

    The Output Control Center is strangely blank, despite setting the driver in EnRoute prior to output. According to the help files, it should show us the driver queue in the OCC.

    Anyone seen this before or have any suggestions? I've already tried reinstalling it, installing to a new folder, etc. We also found the MultiCam job manager software and installed it, but EnRoute 3 appears to be blissfully unaware of it.

    I've attached some screenshots.
    Attached Thumbnails Attached Thumbnails drivers.jpg   occ.jpg   output window.jpg   test square.jpg  

    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 6610 run amuck
    By eforer in forum Multicam Machines
    Replies: 3
    Last Post: 12-26-2011, 05:11 PM
  2. Enroute 4 3D help
    By boriqua056 in forum EnRoute
    Replies: 3
    Last Post: 05-31-2011, 09:38 AM
  3. Enroute 3 help
    By V S Hester in forum EnRoute
    Replies: 2
    Last Post: 11-13-2010, 08:17 PM
  4. Enroute anyone?
    By trooper55 in forum Uncategorised CAM Discussion
    Replies: 1
    Last Post: 05-26-2008, 03:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules