Hello...I just joined and have a problem with a Daewoo puma 10s. It has a Fanuc 10t control with fapt. We bought the machine on auction so I have no prior history on the machine.
The first problem we are experiencing is the spindle starting. In manual it always seems to start, but while running a program the spindle either won't start at all or it will just creep maybe 2 or 3 rpm or it may start and run the programed speed.
I seen mention of which way the chuck clamp position key is in in another post and it may be part of the problem on this machine, the chuck clamp light stays on no matter which position the key is in.
Currently when the machine spindle won't start and run the programed speed I turn the the edit, program, mdi, reference, jog knob to jog and then the spindle will start. Turn it back to program and it will then run the program, but it is a pain and I am trying to get to the bottom of this.
My program looks like
t101 g97
s120 m03
g00 x10. z1. m08
z.2
I have also tried g97 s120 m3 all on one line and it won't work either or should I say it works sometimes, sometimes it won't. Never seems like it messes up with any consistency.
Thank you,
Kyle