Ive been looking @ 2 milling machines and have some questions.
http://www.harborfreightusa.com/usa/...egoryName=null
and
http://www.harborfreightusa.com/usa/...egoryName=null
Here is my dillemma. Is the Y travel supposed to be skimpy? Do i have to buy a full size bridgeport to get anywhere close to 12" travel???
With the second one, with the vertical shaft being round, does this result in much chatter when the mill is running?
This one gives me a bigger table, but the smaller one does not have the round "neck".....
Any advice on these machines would be great.
TIA