Hi all,
I am a newbie to the forum, look like a good bunch of people. We have a biesse rover a3.30 cnc machine. We are starting to create kitchen carcasses in flat pack for fast production. We have always worked the old and slow way of drilling holes/ cams etc. i.e x= 100 y= 60 5mm drill bit. Additional page repeat steps of 32 repeat 20.
My question is, I would like to start using the formula way where we can type in x= lpx/3 (which we have the software, biesseworks) so it divides into 3 holes along the length, (side of wood, not top) I tried today, first hole appeared in a third of the board, but I can't repeat.
Sorry if it doesn't make much sense, but please any help would be truly grateful
Results 1 to 2 of 2
-
01-31-2012, 08:20 PM #1
Registered
- Join Date
- Jan 2012
- Posts
- 0
Please please help! Biesse rover a3.30
-
02-01-2012, 11:54 AM #2
Registered
- Join Date
- Jan 2012
- Posts
- 0
Figured it out now
Reply With QuoteSimilar Threads
-
Biesse Rover 22
By paul sharpe in forum Education - Teachers and Students HangoutReplies: 3Last Post: 09-22-2013, 09:35 PM -
3D en Biesse Rover A 3.30
By larten in forum SpanishReplies: 1Last Post: 11-06-2012, 04:01 AM -
BIESSE ROVER 346
By Bob at MFD in forum BiesseReplies: 0Last Post: 03-29-2011, 11:29 PM -
Biesse rover 342
By jimbbk in forum BiesseReplies: 1Last Post: 02-26-2011, 09:22 AM -
need help rover biesse 24
By neon_x in forum CNC Machining CentersReplies: 6Last Post: 12-05-2009, 08:22 PM
Posting Permissions
