[Carlos1298]

Hi,

I'm new with CNC machines and need to make RTA (ready to assemble) kitchen/bath cabinets. Need to know the following:
1) if a Biesse Rover 346, year 1993, can do nesting
2) have problems with the machine because it does not start. Nothing appears in the monitor.
3) what program is needed to run this machine? I have the eCabinet Systems software but these guys told me it won't work (machine too old). What do I need to do in order to give the machine the instructions what I need it to do?

Thanks for your help!!

[honeyabby]

Hi Carlos,

Here is Abby ,from manufacturer for CNC Router. Could you send me pics and Videos of your machine? Then we could help you well.

My email address: [email protected].

[MarkT]

It can nest but you would have to convert the table to a flat table for best results, it is designed to panel process. Screen blank, could need new monitor, could need new control? The onboard software with the machine is CN RT480 or NC481, its primary intent was to parametrically program at the machine or through an offline version of the software. Many aftermarket CAM packages do have post processors for this control

Mark T.
CNC Custom Services - CNC Service, CNC Support, CNC Training for the CNC Woodworking Industry focused on CNC Routers and CNC Point-to-Point Machines.