[pointer]

JUST STARTED RUNNING THIS MACHINE. IT CUTS JUST FINE BUT WHEN THE WIRE BREAKS IT WILL NOT RETURN TO CENTER RETREAD AND RETURN TO THE BREAK POINT. AUTO RETURN AND BREAK POINT RETURN BOXS ARE BOTH CHECKED. THANKS

[Royster]

You might find your breakage limit is set to 1 set it higher to make it recover. with the skip function used too it will retry the amount you set it to if it breaks a final time it will rapid around the profile and move to the next assuming if you're using the micro-joint and M01 functions

HTH

[pointer]

i will try that thanks