I just purchased Plasmacam from a company. The table was used for demonstration on expo's and really cut just one time. I think an unexperienced user assembled table wrong and something bad happen. I'm talking about connecting wrong x and y cables. They told me that the gantry try to go home and hit the end of carriage. Is true because when i verifyed the tooth belt is very used in a small portion.
Anyway... the transaction was a bargain and at that time i thought i can repair.
Every test is ok. I got response from encoders. But i got this message: short circuit in power to one or more of these motors: carriage gantry Z.
I really think it's a wonderfull machine and don't desirve to just sit there unused.
Anybody experienced same error? Any solve to this problem?