WARNING: this is NOT for your machine! This is g-code used on a Mazak but I think it is reasonably generic and might still be of use when compared to your manual.
Code:
(Part Transfer)
N100
G0G28U0
G98
M307(SP2 CHUCK CLOSE)
M901(SP1 Select)
M202(sp1 turning)
S1500 M4(Turn on SP1 to clean)
M902(SP2 SELECT)
M302(sp2 turning)
M303 S1500(Turn on SP2 to clean)
G4 X1.0
M358(SP2 air blast)
M305(stop SP2)
M5
M200(MILLING MODE START SP1)
G0 C0.0(SP1 ORIENT to 0.0)
M300(MILLING MODE START SP2)
G110 C2(sp2 select for C moves)
G0 C30.0(SP2 ORIENT to 30.0)
G111
M306(SP2 CHUCK OPEN)
M540(TRS-CHK MODE START)
G0B-17.0(1ST APPROACH FOR MOVE, POS. STOCK STOP)
G1B-18.82F200.(POSITION FOR PRESSING START)
M508(PRESSING START)
G31B-18.865F1.0(END POSITION FOR PRESSING)
M509(PRESSING CANCELLATION)
M541(TRS-CHK MODE CANCEL)
M307(SP2 CHUCK CLOSE)
(G4X0.1)
M206(SP1 CHUCK OPEN)
G0 B0(SP2 MOVE HOME)
M202
M1