Attached is a PDF of what the LED pattern means on a FMDC.
George
Thread: Fmdc Led Pattern Decode Table
Results 1 to 3 of 3
-
11-17-2005, 04:26 PM #1
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Fmdc Led Pattern Decode Table
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
11-17-2005, 11:38 PM #2
Registered
- Join Date
- Nov 2005
- Posts
- 72
I was looking at this the other day (have the same PDF). According to this the error I get is " 9513 counter failure ( S6, IC 32 ) " I had a friend of mine look at this board before but there is so much on it he did not know where to start. Could we assume the problem may lie somewhere related to IC 32 on the board? Appears to be a Z axis chip. I swapped it with the X and made no difference. Also, what is "S6"?
Originally Posted by machintek
-
11-19-2005, 12:30 AM #3
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
I would need to find a legible schematic of a FMDC or see a board. Next time at the office, I will see what I can find.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With Quote
Posting Permissions
