I have [pminmo daught comm] interface:
title=DIY4axisinterface
(I cannot post a direct link as this is my first post)

and currently trying Kcam,

and I would like separate x-y-z limit sense contacts and a combined home sense for all three ( if that is the best way to set it up),
but I cannot figure out how to wire it to the interface for separate x-y-z and combined home, then how to setup the ports for this.

Do I need to change to different software???
How do I set up the wiring and ports... plz help

At this point I am only using x,y,z and not yet a-axis, but it is a 4 input board and I would like to use a as well in the future.