[ghm195]

Hello friends!

I´m new here, located in Austria and since a few mounths user of a Fadal 4020 with 88HS control system (and untrained such in english than in programming 88HS) and ask for help!
In using a circle pocket cycle I cannot find the possibility to mill the pocket in steps! It always mills the fully depth in 1 cycle!!! This is not usable for a Pocket with 9mm Dia and 30mm depth.
The problem is always the same in the other pocket cycles and the drill / mill function.
Please, can you give me an idea to crack the trouble?

With best regards

Guenter

[PGrantz]

Feel free to call Douglas Salguero, 818-727-2100 or email at [email protected] to answer any Fadal programming question. He has been the senior Fadal programmer for the factory for over 20 years and would be happy to help.

[carbidecraters]

You need to add a subroutine and a z depth increment each time you bore. Or get a CAD system (best option)

[Chrismee]

Guether.

Move to center of hole with A 5mm dia e/mill then

G1Z0F2.0
G91Y2.0
G3J-2.Z-1.L30
J-2.0
G1Y-2.
G90G0
Z75.

Chris

[email protected]