Hi Everyone,
I originally posted this in "Machine Problems, Solutions , Wireless DNC, serial port" but this forum seems a better fit. I apologize, am tired, no coffee.
This spindle drive is in a Hitachi Seiki HT25S. When machine is turned on in back, the drive gets proper 3-phase voltage but no LED's come on, nothing on single 7-segment LED. Shouldn't at least the "charge" LED come on? All fuses check good. The piggy-back powersupply on the front control board was sent out and no problem found. I've read the manual and it implies that if the drive has proper 3-phase voltage applied, it should come to life (with errors), whether anything is hooked up to it or not. Maybe I read it wrong?
Any help is appreciated, thanks in advance.