584,833 active members*
5,670 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2010
    Posts
    7

    Burny 2.8 controller parts

    Does anyone have any parts for a Burny 2.8 controller?

    I am using this controller on a plasma cutter and when the machine cuts in either just the y direction or just the x direction it cuts fine. When it needs to travel both in the x & y direction, like a miter is when the machine stutters and creates a jagged cut.

    Also I used to be able to download from my pc to the controller at 2400 baud, but I had to set it to 1200 baud for the entire part to load.


    Any ideas?

  2. #2
    Join Date
    Oct 2010
    Posts
    71
    This could be as simple as the speed settings for the x axis and y axis are not matched. Run the Burny speed calibration routine and see if this helps. Unfortunately its been a long time since I used a Burny controller so I cant remember where to find it. I do have some parts for a Burny V though.

    Regards

    Ian

Similar Threads

  1. Need Siemens 802C Controller Parts
    By LaysMachinist in forum SIEMENS -> GENERAL
    Replies: 6
    Last Post: 02-22-2011, 04:24 AM
  2. anyone got burny 2.5 parts???
    By xjdubber in forum Waterjet General Topics
    Replies: 1
    Last Post: 09-15-2009, 01:11 PM
  3. Dyna DM2400 - need controller,parts
    By base2 in forum Benchtop Machines
    Replies: 7
    Last Post: 07-16-2009, 01:19 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •