edit -

I rebooted Rhino and the problem went away. Not sure what was going on. Thanks anyway.

K

================================================== ====

Having trouble getting off the ground today.

For some reason I am getting a G0Z4 for my first rapid. This would be fine, but there isn't 4" of space above the part, so I get a Z error right off the bat. I have recreated the toolpaths with the top of the part reselected and at Z0 but cannot keep it from sending the Z to 4" (or trying to). I have my box clearance set at 1", stock to leave at zero. I feel like this is something very simple, but I cannot put my finger on why it is stuck on 4". What am I missing? There must be a simple setting somewhere.

Thanks,
Karl