[CNC-Joe]

I went to look at a Bridgeport Interact 421 vertical machining center.
It has a GE Fanuc O-Mate M controller on it.
The machine kept having an alarm, and after paging down through the screens
It had an error message: "101 P/S Error"

The manual was no where to be found.

Anybody have any idea of what this could be?

Thanks for any help you can give.

CNC-Joe

[Al_The_Man]

That is a 'Clear memory request'
Programs, that is.
set PWE bit to =1 hold DELET key while powering up, all programs will be deleted.
Remember to reset PWE back to 0.
Send a email add via PM for manual.
Al.