I am adding these axis to my machine 1 have bought 1010-5 cards and the eproms i have both ac and dc eproms have it all up and running i can jog the axis with hand wheel but i am not getting encoder feed back to the control,
I am wondering if there is a juper config that makes the controll look at the encoder port on the 1010 -5 card , I have plus minus voltage going to my drive , but i am not getting feed back to the controller for some reason , i am connected to the encoder port of the 1010-5 card been working on this for a while , still cannot figure out the feed back, i have saved up money and bought stuff from ebay over a time period , thought i had everything i needed,
I bought some teco servo packs , they seem to work good , used these motor and drives before on diffrent projects and they work good .
I can also hook battery box to the card and move the axis , can jog it with the controll but no postion feed back
Any help would be appreciatted i am almost there !
Thanks Barry