Hi there,
I started lurking around after discovering Lenne's CN on BitTech about a year ago.
Since then I became a bit obsessed with building a CN.
At first, I dreamed myself building a huge one then the cost for such a machine bring me back to reality
so I planned to build a tiny one with drawer rail or so .
Eventually I decided to put some money in it to get something that would allow me to mill plastic, wood
and (I wish) 5mm alu plate even if I got to do it in severall time.
I began by buing this kit on ebay.
I am waiting for them to get started with the plans.SBR16-300/800/1300mm(6supported rails and 12 SBR16UU bearing blocks)
3pcs RM1605-350/850/1350mm with ballnuts and end machined
3sets BK/BF12 end support with locknuts and circlips
3pcs couplers 6.35mm*10mm
I will get the electronic once the frame is going to be usable.
Due to lack of money I intended to use MDF to build it, but I might have an opportunity to get some 40*40 & 40*80 alu
profiles , I'll keep you posted about that.
In the end I would like to get somthing like Lenne's V1
Sorry about if there are some mistakes, I'm still trying to improve my english.
Feel free to post any comments or suggestions.
Z