Hello,
I have a 1989 Mori Seiki SL20 with a Yasnac control. The parameters start at N6000. My question is, how do you edit the incorrect parameters? Also parameters 6030-6049 are gone. Thanks for your help. Machine seems to be working fine, other than when a G76 is called up. It will run through the threading cycle, but the feedrate is way too slow.
:drowning:
Results 1 to 2 of 2
-
04-12-2012, 03:13 PM #1
Registered
- Join Date
- Apr 2012
- Posts
- 0
Need Help setting/changing parameters
-
04-20-2012, 06:33 PM #2
Registered
- Join Date
- Apr 2012
- Posts
- 0
To edit the 6000 parameters you must be in MDI mode the system switch on the back control door must be set to #7 . Once you cursor to the selected parameter you then press the Insert key which will move the cursor to the right, then edit as required. You must use the insert key again when you change pages. For the 6030 parameters you need to put system switch in position #4 and then exit & re-enter the parameter page.
Hope this helped..
Good Luck
Reply With QuoteSimilar Threads
-
Changing the parameters for ballscrew Fanuc 15M
By kningzer in forum FanucReplies: 18Last Post: 04-11-2019, 06:09 PM -
Changing parameters in program?
By chucker in forum FanucReplies: 2Last Post: 05-03-2011, 02:41 PM -
Changing Parameters in the Program
By danrudolph in forum CNC Swiss Screw MachinesReplies: 4Last Post: 10-21-2010, 10:03 AM -
Methods of changing parameters
By sinha_nsit in forum FanucReplies: 0Last Post: 10-05-2009, 02:41 PM -
Changing S/N setting 26 to cancel alarm 144
By robard in forum Haas MillsReplies: 5Last Post: 03-14-2009, 05:32 PM
Posting Permissions
