Please help! I am looking for schematics for a Model 1 BP milling machine.
Please help! I am looking for schematics for a Model 1 BP milling machine.
From, Bob Moore
http://www.immrepair.com
Hi,
go here:
http://www.frugalmachinist.com/bp1j.html
-Paul
I am bothered with myself for not asking for electronic circuit board schematics for this machine. If you can send me to the right place it will make my day.
Thanks,
From, Bob Moore
http://www.immrepair.com
There is a full manual download in pdf format. go here:
http://mysite.wanadoo-members.co.uk/...ges/index.html
it's 132 pages and beginning with section 7.1 is the wiring schemactic for a 1J and 2j bridgeport, I believe.
-Paul
Perhaps, you need to be more specific.
Typically there is not a schematic for a series 1 standard.
There are schematics for a power feed. 6F or 8F?
Or did you mean a NC or CNC?
Or did you mean mechanical drawings?
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks, i am looking for the electronic schematics, for the CNC series 1 Milling Machine. Thanks,
From, Bob Moore
http://www.immrepair.com
Hi Bob,
I have a complete manual on a Series 1. Was control circuitry or main power schematic you wanted. Which No. Boss control, not sure if they are different.
Perhaps you can help me, have you got any schematics on 70's 80's Metal Meccanica's.
Dave
Thanks for your reply. I need the control circuit schematics for the electronic stepping motor control boards. If you have this information it would help a lot. Thanks, Bob
From, Bob Moore
http://www.immrepair.com
I emailed you what I have. Let me know if you get it.
Darek
I will dig them out and scan them. Have you got problems with one then? The boards are quite solid on them but the drive transistors fail regular if they are over pulsed. Ended up driving the boards with an allegr chip via pc, but still got the transistor problem.
Have you got anything on the Metal Meccanica?
Dave
Yes, I have a problem with the Z axis. I found that the transformer used for the z axis had a shorted primary winding puting out too much voltage and burnt the transistors. I rewound the transformer and replaced the transistors, I cant regulate the higher voltage on the Z axis only. so I think that the schematics will reduce my trouble shooting time.
I am looking forward to seeing if I can get the schematics. Thanks, Bob
From, Bob Moore
http://www.immrepair.com
Bob,
Have emailed the schematics to your company, hope they help.
Any luck with Metal Meccanica 14SRE molding machine schematics.
Dave
Thanks a lot Guys, I think what you sent me will help a lot.
From, Bob Moore
http://www.immrepair.com
I am also looking for power and control schematics for a Series 1 CNC. Can anyone send me what they have?
Thanks.
--Eric
Try machinemanuals.net as they have some BOSS maintenance manuals on CDROM.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
My 8f Bridgeport Drive Died. Looking For Schematics For The Board And Motor Switches What Have You .
John
I too am looking for boss electrical schematic for a Bridgeport Boss. All so does anyone know how to identify which Boss model I have?
Hello! i`m looking for the electrical diagrams for a psu bridgeport a025275....Can anyone help me?