I am going to use an arduino with grbl to control my cnc. Which post processor can I choose to generate the correct gcode?
Thanks
I am going to use an arduino with grbl to control my cnc. Which post processor can I choose to generate the correct gcode?
Thanks
My experience with GRBL has been good overall.
I have used Mach 3 as a post and edited the g-code file to remove tool change commands.
Several G-code senders will report back errors that GRBL doesn't like. Usually just deleting the offending line will allow it to run.
Good luck with your endeavors.
I use the attached one.
Just remove ".txt" from the file name and place it in the PostP folder (or My_PostP folder).
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.