[DaRipper]

Hi There,
I have had my router for 6 months now and have been using cut3d which post processor is G code mm(*.tap) for the NC Studio-V8
Now I have VM but it hasnt got this post.

Can any one help me as to which post processor might work in VM
or even one that is close and i will try and edit it.

Is this even the right approach to this?? any advise would be helpfull. Thanks

[BanduraMaker]

What controller are you using? NC studio looks to be a breakout board, not a controller.

[DaRipper]

Hi, Its NC Studio -V8 Version 8.230

[BanduraMaker]

What controller are you using? Eg "Mach 3"

[BanduraMaker]

I looked around on the internet a bit and it looks like there is controller software named NC studio but it was hard to find much information. What I could find was this: SALE CNC Router Milling, CNC Laser, CNC plasma machine, China, Servo Motor Drive, UK, USA, Italy, Spain, Thailand
http://www.salecnc.com/manuals/CNC_R...ManualV4.4.pdf

I would recommend sending an e-mail to Mecsoft and have them help you create a post processor. Tech support is free to legit users.