This was a private message with Jackal66.


My friend John Tidrick has a nee mill with an anilam 3300 mk control. He can't keep it running We are retrofitting it with PMDX & Geckos. I can't figure out where the servo voltage comes from. I don't find a transformer for the servo voltage. If I need to buy a transformer how many amps do I need? My friend, John got his PMDX 126 and the |Geckos 320x's. I got 57 volts on my Hurco (AC) I think. Most of the low voltage supplys are switching.
Dave


Ask Al_the_man on CNCzone & see what he says.

57volts AC x 1.414 ( bridge rectifier ) = 80.59 volts DC to power the Geckos.

I am unsure about the amperage, it depends on the draw of the motors. Al can tell us that.

Jack

I must have less than 57 volts . I have 77.5 volts DC.
Dave