Can someone guide me in the right direction. Im new to X6 and I can't figure out how to convert splines to arcs. Im used to version 9. Im doing a basic 2D toolpath and splines leave terrible machine finish.
Thanks
Can someone guide me in the right direction. Im new to X6 and I can't figure out how to convert splines to arcs. Im used to version 9. Im doing a basic 2D toolpath and splines leave terrible machine finish.
Thanks
"Edit" then "Simplify" will do it.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
I also sugest you use this to link and save to your computer.
http://www.mastercam.us/artwork/v92xfunctions.pdf
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .