Originally Posted by
vetsen
I don't understand why M15/M16 won't output when I add them to lines 752 and 753 like below.
752. Laser-Plasma-Waterjet Cutter On Code? "M15"
753. Laser-Plasma-Waterjet Cutter Off Code? "M16"
I have downloaded a plasma post and was able to change M11/M22 to M15/M16
These changes came through.
I know about the debug mode.
Steven
V23 Plasma blocks = 702 and 703.
Code:
700. Laser-Plasma-Waterjet Cutter Width Prefix? "D"
701. Laser-Plasma-Waterjet Pierce Height Z Location Prefix? "Z"
702. Laser-Plasma-Waterjet Cutter On Code? "M03 ( CUTTER ON )"
703. Laser-Plasma-Waterjet Cutter Off Code? "M05 ( CUTTER OFF )"
710. Laser-Plasma Gas Assist On? "M52 ( GAS ON )"
711. Laser-Plasma Gas Assist Off? "M53 ( GAS OFF )"
712. Laser-Plasma Gas Assist With Air? "M712 ( GAS WITH AIR )"
713. Laser-Plasma Gas Assist With Oxygen? "M713 ( GAS WITH OXYGEN )"
714. Laser-Plasma Gas Assist With Oxyacetylene? "M714 ( GAS WITH OXYA )"
715. Laser-Plasma Shutter Open? "M715 ( SHUTTER OPEN )"
716. Laser-Plasma Shutter Closed? "M716 ( SHUTTER CLOSED )"
717. Laser-Plasma Pulse Frequency Prefix? "F"
718. Laser-Plasma Power Setting Prefix? "P"
719. Laser-Plasma Torch Height Control Prefix? "T"
730. Waterjet Abrasive ON? "M730"
731. Waterjet Abrasive OFF? "M731"
732. Waterjet Vacuuum Assist ON? "M732"
733. Waterjet Vacuuum Assist OFF? "M733"
734. Waterjet Pressure Low? "M734"
735. Waterjet Pressure Medium? "M735"
736. Waterjet Pressure High? "M736"
In V24 they are different, like you show.... You may want to go redownload a V23 post to start with....