584,837 active members*
5,122 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > View parameter#5131 & 5132 - Fanuc 21i-T
Results 1 to 5 of 5
  1. #1
    Join Date
    Mar 2008
    Posts
    10

    Question View parameter#5131 & 5132 - Fanuc 21i-T

    From the controller [Fanuc 21i-T], I would like to view parameters #5131 & 5132.
    When I go into the System/parameter page, the parameters stop at 4150 [or around there] and start again at 6000.

    Does anyone know how to view the 5000 parameters on this controller?

    Thanks for any help you can offer!

  2. #2
    Join Date
    Mar 2010
    Posts
    0

    View parameter #5131 & #5132

    Not sure why these are not visible, but an easy way view them is to transfer them to an unused # parameter.
    #100=#5131
    #101=#5132
    Give it a try!

  3. #3
    Join Date
    Mar 2008
    Posts
    10
    Didn't think of doing that!
    [doh~]

    THANK YOU!

  4. #4
    Join Date
    Aug 2011
    Posts
    2517
    those parameters are some of the settings for the canned cycles. perhaps your machine has some other screen to configure that via a MTB-added screen.
    Otherwise, the easiest way is just punch out all of the parameters to a PC via RS232 then look at the resulting text file and you can see everything.
    If you can't see them but need to change them you could probably use G10

  5. #5
    Join Date
    Mar 2008
    Posts
    10
    Thank you!
    The parameters are part of the G71 canned cycle.
    I don't want to change the settings, I just wanted to see what they were at before I ran a different configuration of the program. I needed to 'show' them to someone else to end a disagreement.

Similar Threads

  1. Fanuc 11 G54 parameter
    By staffb68 in forum Fanuc
    Replies: 1
    Last Post: 06-26-2013, 08:21 PM
  2. FANUC 6T PARAMETER
    By hiiesalu in forum Fanuc
    Replies: 3
    Last Post: 01-23-2013, 08:33 AM
  3. Fanuc parameter 901
    By mistux in forum Fanuc
    Replies: 14
    Last Post: 12-04-2009, 06:28 PM
  4. 18i hidden parameter view/change?
    By john k in forum Fanuc
    Replies: 6
    Last Post: 12-22-2006, 07:58 AM
  5. parameter fanuc om-d
    By dlmusinage in forum Fanuc
    Replies: 1
    Last Post: 05-17-2006, 10:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •