Dear Concern Person,

We have a DECKEL MAHO DMC 63V CNC Machining Center; the Specs of the Controller are as follows:
TNC 426/430
HEIDENHAIN
NC: SOFTWARE
280475 16

The machine was functioning smoothly when it was last shutdown at the end of the working day. When we started the machine on the next morning, we are getting the Alarm:

“LE 430 LOADER
Hard Disk problem 3 Encountered
You can try auto repair which may result in data loss
Auto Repair [Y / N]”

We tried to auto repair by selecting “Y” but the alarm remains. We have removed the Hard Disk and tried to recover the data but have been unable to do so. Unfortunately, our back up data has also been lost.

The electronic repair engineer has indicated that if the NC software for this controller is available they would be able to copy that in another hard drive and install it so that our machine will work smoothly.

We would deeply appreciate if someone could send us the software.

My email address is: [email protected]

Thanks,
Adnan Gulzar