We have a Cincinnati Arrow 500, and the last we ran it was a couple of months ago, when it worked fine. However, now when I try to align the machine, I get the following error:
"A axis has not unclamped within the time allowed
Check the operation of the solenoids and proximity switch settings.
SL_A_UNCL should be ON
PR_A_CLMP should be OFF
PR_A_UNCL should be ON
CR_A_ENBL should be ON
CR_A_READY should be ON"
The problem is that we have is that we have never had a fourth axis hooked up to the machine, and I have no idea why it would be giving me this error.
Any suggestions?
Thanks
Results 1 to 3 of 3
-
06-26-2012, 05:06 PM #1
Registered
- Join Date
- Mar 2012
- Posts
- 0
Cincinnati Arrow 500 thinks it has 4th axis....
-
06-27-2012, 03:21 AM #2
Registered
- Join Date
- Apr 2004
- Posts
- 353
With E-Stop pressed, On pendant select "Setup" then "Rem Axis". In there you can use the F1/F2 buttons to remove or install the 4th axis.
(Not at the machine right now, but from what I remember this should work)
-
07-02-2012, 02:32 PM #3
Registered
- Join Date
- Mar 2012
- Posts
- 0
That did the trick thanks!
Reply With QuoteSimilar Threads
-
Need Help! Cincinnati Arrow
By vbolhov in forum Cincinnati CNCReplies: 3Last Post: 09-22-2010, 03:51 PM -
cincinnati arrow 500 y axis sticking
By andywn in forum Cincinnati CNCReplies: 2Last Post: 09-13-2010, 04:22 PM -
Cincinnati Arrow 750
By overflowmachine in forum CNC Machining CentersReplies: 0Last Post: 09-03-2010, 10:49 PM -
Cincinnati Arrow 500
By Mr Bonavita in forum CNC Machining CentersReplies: 4Last Post: 07-02-2009, 07:24 AM -
Cincinnati Arrow 500 Setup
By professor in forum CNC Machining CentersReplies: 2Last Post: 11-13-2007, 10:34 PM
Posting Permissions
