I'm looking for a place to discuss a bunch of GRBL things. Like a community forum.
Where would I find it ?
Are there any GRBL people here ?
I'm looking for a place to discuss a bunch of GRBL things. Like a community forum.
Where would I find it ?
Are there any GRBL people here ?
The GRBL discussions that I have seen here have been scattered in various places.
One place that might be good would be Open Source Controller Boards - CNCzone.com-The Largest Machinist Community on the net! (but there hasn't been much activity there).
(even though GRBL is software/firmware and not actually an open source controller board, when running on an arduino board it sort of is)
Thanks.
Yes you can also discus about it in this forum and check this forum.
shapeoko.com/forum/viewforum.php?f=3
You can also discuss here about the all type of GRBL topics.