[Dahlberg]

Hello everyone, I can`t get mach3 to run my gcode, every time I try to start the program it comes up with a error saying: Error found. Art code: 9991, atttempt recovery. is it mach 3 causing problems or could it be my pp.
I am sooooo close anyone please help

Best from Denmark

[Dahlberg]

I Also have another problem. I cannot get mach3 to start my spindle with an M3, I have tried both M3 and M3 S8000 but no luck. I can turn on the spindle once, by using the spindle toggle when I have done that once I have to reset mach3 again. It has all been working before i connected some pcb touch plates,

Any thoughts??????

[Jincamty]

Same error whenever I try to tune the motors. :-(

[Jincamty]

Mach3 USB. Remove unnecessary plugins from the Mach3 folder. Worked for me.

[digifabcnc]

Mach3 USB. Remove unnecessary plugins from the Mach3 folder. Worked for me.

Can you indicate which are the necessary plugins please?

[dr67]

Can you indicate which are the necessary plugins please?

For mine is was NVEM_NEW.dll

I had been using the updated 3.0 version of the file anyhow.