[MauricioBachega]

Hello, I have a cnc ROMI, with the controller Fanuc 21i-TA, and the manual says it has a 'Work' page, where is the G54, G55, etc, but when I press Offset, appears only 'Work Shift' softkey, and where it was to have the 'Work' is empty, someone could tell me how to activate this page? I work with pieces that makes in two phases in same jaw, so it's very complicated to use two tool offset for each tool, I would use the G54 and G55.
Thanks.

[botha.y]

PM sent.

[cmobilaah]

If you go onto the offsett page and press the softkey at the right of the screen, It should bring up other options. It´s been a while since i used one but i ithink it is around there somewhere or if not when you go onto the workshift page press the softkey on the right of the screen and see what options come up I use a fanuc O1T now mostly as well as okuma and when i press work it comes up straight away.

[MauricioBachega]

I tried this, but dont have the Work page, i heard its an optional...
Thanks anyways

[fordav11]

yes, G54-G59 is an option, very easily enabled with the correct info.... which of course can't be posted here publicly

[Eaoisionni]

Hey guys, could someone please pm me how to activate this option [that was purchased with the machine] It's a Hardinge Cobra42 with the Fanuc 21-T control. Tired of reseting all of tools for any new z work piece offset. Thanks in advance

[adtoolco]

Hi all,

I'm in a bind. My Okuma Howa Act-4 has a gremlin and is down. I need to finish a sizzling hot job and am switching to
another lathe now and of course it doesn't have the g54-g59 activated. Could someone please share how to activate that
option? Many thanks in advance.

-Chris

[memoryman]

That is a Fanuc option. I can send the info by private message.

[HatfieldInd]

I have a '97 Clausing Storm 110 and need to activate G54 as well. Same parameter changes, I assume? Fanuc 21i-T controller

[singist48]

Could you pm me the info please?

- - - Updated - - -

could you pm me the info please??

Thank you

[nate13]

I’m having the same issue with the same machine, could some one PM me the info please,

Thanks

[Forasaka]

Hi all. i I bought a Cincinnati hawk200 with the Fanuc 21i-T controller and there are no such options (G54-59)
Who will help with this problem?

[inthebay]

also looking for help via DM - Fanuc 21-T

[memoryman]

pm sent.

[dclark231]

hi i know it has been a while but was wondering if you would be willing to impart some knowledge via pm on this subject matter?? I have been trying to figure out how to unlock the g54-59 on the fanuc 21-t.

[ThiagoIntercnc]

Please you can send me ?