The control runs faster then the feed rate written. The code is as follows;
T5 M6
G80
G20
G17 G59 G80 G90
S6000 M3
G43 Z.12 H5
G83X-7.25 Y- 3.45 Z-3.5 R.1 Q.625 F50.
X-8.25
X-9.25
G80
The control runs at about 200 IPM even though it shows 50 IPM. If I turn the feed over ride down to 10% it looks like it is running around 50 IPM.
Does anyone know if the code is the problem, I tried changing it to G73 and it seems to run OK.