The part you need is called a bush.
They are very common in a range of sizes, but the part you need has a 1mm wall thickness which is unusually thin. Most bushes are 2.5mm wall. I.E. a 25mm ID and 30mm OD is common.
If you bought something similar to this 30 x 35 x 100mm BRONZE BUSH | Bearing & Engineering Supplies | Online Shop and somehow turned it down to 32mm it might work.
There will be a solution to this problem, so don't listen to the mockers in this thread.
If this is really only for one car though, you should just buy a different set of bearings.
Good luck.