I have been running my 0704 on the Hoss phase 1 ste up for a while but I have purchased the e-bay C7 ballscrews to final do the up grade.I built my mounts as per Hoss's updated prints for phase2 with the metric ballscrews.I need the a print of the openings on the carriage for the ballnut mounts and the table too if there is any mods needed.Any help would be appreciated.Thanks Dave.
Results 1 to 2 of 2
-
08-23-2012, 01:12 AM #1
Registered
- Join Date
- Jan 2011
- Posts
- 51
G0704 C7 BALLSCREWS carriage prints
-
08-23-2012, 04:57 PM #2
Registered
- Join Date
- Jan 2010
- Posts
- 151
AFAIK the cutout is just for ballnut clearance, it doesn't have to be anywhere near precise to need a print. sit the ballnut on there and trace around it with a sharpie. cut it deep enough so the ballscrew almost touches.
am
Reply With QuoteSimilar Threads
-
Misumi C10 ballscrews = Chinese C7 ballscrews?
By Shalecnc in forum DIY CNC Router Table MachinesReplies: 4Last Post: 08-08-2012, 08:42 AM -
looking for some practice prints
By Kennyb1013 in forum Mentors & Apprentice LocatorReplies: 4Last Post: 06-07-2012, 02:30 PM -
Ballscrews for G0704 Clone from linearmotionbearings2008 ?
By jdurkin in forum Benchtop MachinesReplies: 32Last Post: 01-06-2012, 01:09 AM -
saveing prints
By 1234567 in forum BobCad-CamReplies: 6Last Post: 11-24-2009, 11:03 PM
Posting Permissions
