I use these on most parts that i make and i'm looking to cut down the time it takes to draw them in, does anyone know of a feature that i can use to automatically insert these boxes into each part onto the RefPlane that will dimension them correctly?
Say the part is 3m i would draw a box at either end around 150mm, and 3 in the middle evenly spaced at around 450mm.
However, if the part was 500mm i would just need 2 boxes at around 100mm at either end.
Not sure if this is even possible but i would appreciate any help, if my explaination is hard to understand please say.
Cheers