[ken95101]

Hi All

I am a long time fan, first time post.

I have a akira seiki lathe asl 17 with a mitsubishi meldas 50 control, ran fine for several years, today, smoke comes out of the back of machine, I got a S01-33 servo alarm, I did some looking up, I believe is “over voltage” alarm. I guess some how, power amplifier exceeds 400v, I call up service, tech is 1 week out, can anyone help me with this matter? Firstly, is it a easy to fix problem, is this something I can DIY?, what need to be replace? What does the part looks like? Some picture would help.

I am in CA, if you can fix my machine, please send pm.

Thank you in advance.

Ken 95101

[underthetire]

Call premier machine works. He works on those all the time. I'd pm you but can't figure out how to do it on tapatalk. He's in Livermore, send me a message if you want his number. It's going to be a drive replacement I'm sure.

[ken95101]

Thanks Mr. Tire

any idea roughly what it cost? $1000.00 or $5000.00