584,830 active members*
5,681 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Sep 2012
    Posts
    0

    Hypertherm 600 consumables

    Hey All,
    I recentally got in possesion of a plasmacam table with a hypertherm 600 torch. Currentally it is running a drag shield and is less than optimal. Currentally it creates a curf that is too wide, and create a bit more dross that I'd like. The height is set properly and speeds are the settings that hypertherm recommends in the manual, i have modified them back and forth a bit as well. I believe that switching over the shield to a machine shield, as well as fine cut consumables would potentially help the curf issue, and potentially the dross as well. Im looking here:

    FineCut Parts & Kits

    specifically the 220326 and the 220330

    should i also change the swirl ring?
    How is consumable life, i assume less, but by what margin.

    Additional details:
    The table runs DHC, and I typically cut 16Ga 11Ga and 1/4", will I have problems with the 1/4" with the fine cut consumables?

  2. #2
    Join Date
    Sep 2012
    Posts
    0
    in retrospect, it appears as though fine cut would work well for my sheet metal, however maybe not so much on the 1/4" material, is there a better combo of consumables that i can use for the 1/4" thicker material?

Similar Threads

  1. Hypertherm Consumables / Jim Colt
    By magma-joe in forum DynaTorch
    Replies: 2
    Last Post: 09-21-2015, 09:57 AM
  2. Hypertherm Finecut Consumables
    By none in forum Hypertherm Plasma
    Replies: 2
    Last Post: 04-02-2012, 03:46 PM
  3. Used Hypertherm consumables needed.
    By AccuFast2D in forum Waterjet General Topics
    Replies: 21
    Last Post: 10-01-2009, 01:47 AM
  4. hypertherm consumables
    By Pure-Powder in forum Waterjet General Topics
    Replies: 14
    Last Post: 06-04-2008, 04:26 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •