Is there a way to change (lessen) the default dwell time in Mach3?
I'm running a very basic drilling cycle in UHMW with a 900rpm so if the bit is not totally up to speed, no problem.
I'm too impatient to wait the few extra seconds of dwell after the spindle starts. (Series 1 PCNC1100, no upgraded spindle).
I did find a "cheat", by pressing spindle start (I use alt-R on the keyboard) again right after the spindle starts, it will skip the dwell time and run the code. But if anyone knows how to change the default, that would help.