Howto G54 G55 etc 8055i
guess I'm getting senile but I cannot get this to work on my Microcut VM1300 when it ought to be simple to do. Running the centre with Fagor 8055i Version15.
Basically I have a program to perform a number of operations with the same tool. I want to repeat this operation a few more times at different positions on the same table - change tools and do the same again with the new tool. Basically, several stacks of work and not one at a time.
I thought that G54-59 would allow me to do this without having to make copies of the same program with allowance for offsets to the next stack.
A) Am I on the right track here
B) If so, is there anyone here that would take some time to set me through it?
Hoping for a helpful hand?
Seeking USER_FUNCTIONALITY always
Regards SnapafunFrank