Hello Everyone, I,m Manuel.
In May 2012 I purchased a very simple Plasma Cutter from China, It includes a Software called Artengrave in wich you draw the geometry and generate the G-Codes in a .NC file, Then I have to load the .NC file into a software named NC Studio.
The problem is the Artengrave software, to me is a little primitive and very hard to understand because of the chinese characters in the buttons, Plus the tests i have runned showed the inaccuracy of the software.
Does Anybody knows about a friendly software and not too expensive to draw the geometries and generate the G-Codes for a plasma cnc pantographer?